Controller Resistor - 16.8 Ohm

Controller Resistor - 16.8 Ohm

New series of resistors for mechanical buttons MB SLOT The particularity of this new resistance circuit is to have a total of 14 resistors with 5 watts of power each, compared to 12 resistances and 1/2 watt of previous circuit .

The advantages are to have a better controllability of driving with resistances 14 and with a greater number of watts better durability and resistance of the circuit .

The resistance circuit is compatible with mechanical buttons MB SLOT and replaceable in all mechanical buttons on the market . The only change will be to cut , one half of the shell in the upper part , in order to install the circuit resistances larger .

To understand what resistance is suited to driving on the same machine , voltage circuit and the circuit conditions , we need to find the resistance that since the first finger ( when you pull out the button from the stop position ) allows a driveability
the machine smoothly. If the guide warns that the machine starts too late , that you drive only towards the end
resistance , we must use a resistor with an Ohm value lower (go from 21 Ohm to 16.8 Ohm) . If the guide warns that the machine starts too early , that is uncontrollable at the start or at the exit of the corners, you have to use a resistor with an Ohm value higher ( switch from 16.8 Ohm to 21 Ohm)

The choice of the value depends in part on Ohm Voltage: at higher volts on the track you need to increase the value of Ohm Since GRIP on track : the higher the grip you need to decrease the value of the ohm and the type of engine and machine, but especially from the driver's behavior .